![]() ![]() USB driver for Windows 7 (courtesy of ariZedA): ![]() To wire your Tarot gimbal to the Naza controller, take a look at this image, courtesy of eirlink and his blog You have to select "Positional." in the gimbal control software (note: this was added with the 1.3 version). It keeps on going down or up, until I center my knob/lever.Ī: This is because it's operating in "Stick Rate mode". Use the gimbal software to see if it switches through the two modes, when you flip your 2 way switch. Be sure to adjust subtrim for "mode switching" if needed. Wiring example would be: I want to change mode and to control tilt. How do I wire it for Tilt and Roll control.Ĭlever people make a special cable for this, so everything is tidy. ![]() Q: I have changed some settings, but now I want to revert to the defaults, what are they? Q: The Gimbal software doesn't remember my settings, even if I remember to "write" them to the flash/configuration.Ī: If you change numeric values, you have to hit ENTER, after you put in the number. You can grab it right here - Q: How do I update the firmware. 1A in charging state.Ī: Latest firmware version is 1.4 (30th of October 2013). Q: Can I use the onboard 5v to charge/power the GoPro Camera.Ī: You will fry the onboard Tarot controller if you do this over a longer period of time. Remember to write settings before you exit. In your software, select mode 2 (positional mode). How do I get "positional control"Ī: For positional control, you need to be on firmware 1.3 or above (currently 1.3 is the newest). Q: I have connected tilt control and it continues to move when I turn my knob on my TX. Adding and modifying the gimbal in anyway, so it can handle other camera's is not supported by Tarot and does require balancing. If using the original vide-out/charging cable from Tarot, the screw must be removed. Be careful screwing it all the way in, since it will screw into the back of your gopro3. If you don't use any cables for the gopro3, then be sure to have the "counterweight balancing screw installed". ![]() Q: Should I balance it, with the GoPro installed.Ī: It is fairly well balanced leaving the factory, but pay attention and make adjustments if needed. It won't level out, since it's too much out of balance. Q: Can I power it on with no camera mounted.Ī: You can, but it's not recommended. Q: What is the mAh usage of the gimbal in operation Use either a stand alone pack (600-900 mAh) or tap into your distribution board or main pack. Including guides, how-to, faq and general info.Ī: 3s is recommended, but 4s will also work. This thread is for keeping various information about the Tarot T-2D gimbal. Those questions should be asked and answered in the MAIN THREAD. This thread is NOT for questions about the Tarot T-2D gimbal, that isn't covered in the FAQ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |